GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The radio has an internal voltage sensor with a dedicated circuit that measures the battery voltage to determine if it is above 9.0 volts.

DTC Descriptor

This diagnostic procedures supports the following DTC:

DTC B1327 Device Power 1 Circuit Low

Conditions for Running the DTC

This DTC shall run only if the radio has power and ground, and the ignition is not in START mode. This DTC shall execute regardless of the battery voltage.

Conditions for Setting the DTC

    • This DTC shall be set as current when the voltage falls below 9.0 volts for 1,200 milliseconds.
    • When the vehicle exits START the radio shall delay checking the voltage for 2 seconds.

Action Taken When the DTC Sets

    • The BCM will not illuminate the charge indicator.
    • A message shall be sent out to notify all other modules of low battery voltage.

Conditions for Clearing the MIL/DTC

In order to clear the DTC from a current status the ignition must be cycled and the voltage shall be greater than 9.0 volts.

Test Description

The number below refers to the step number on the diagnostic table.

  1. This step compares battery voltage with the voltage that the radio calculates.

Step

Action

Value(s)

Yes

No

Connector End View Reference: Inline Harness Connector End Views in Wiring Systems or Computer/Integrating Systems Connector End Views in Computer/Integrating Systems

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, observe the Battery Voltage parameter in the Digital Radio Reciever data list.

Does the scan tool indicate the Battery Voltage parameter is greater than the specified value?

8.8 V

Go to Step 5

Go to Step 3

3

  1. Measure the voltage across the battery terminals.
  2. Compare the battery voltage with the Battery Voltage parameter.

Are the voltages within the specified value?

1 V

Go to Battery Inspection/Test

Go to Step 4

4

Test the battery positive voltage and ground circuits of the radio for a high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 7

Go to Step 5

5

Inspect for poor connections at the harness connector of the Radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 7

Go to Step 6

6

Replace the Radio. Refer to Radio Replacement in Entertainment for replacement and setup.

Did you complete the replacement?

--

Go to Step 7

--

7

  1. Use the scan tool in order to clear the DTC.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

--

Go to Step 2

System OK