Rear Wheel Speed Sensor Replacement FWD

Important: The wheel speed sensor is serviceable only as an assembly. Do NOT attempt to service the sensor harness pigtail.

1. Disconnect the electrical connector (6) from the wheel speed sensor.
2. Remove the rear axle hub and bearing assembly. Refer to Rear Wheel Bearing and Hub Replacement .



3. Remove the wheel speed sensor from the rear axle hub.

1. Install the wheel speed sensor to rear wheel hub.
2. Install the rear axle hub and bearing assembly. Refer to Rear Wheel Bearing and Hub Replacement .



3. Connect the wheel speed sensor electrical connector (6).
4. Perform Diagnostic System Check - Vehicle .

Rear Wheel Speed Sensor Replacement AWD

1. Remove the fuel tank filler pipe protector bolts (2) and remove the fuel tank filler pipe protector (1).
2. Remove the rear seat bottom and seat back. Refer to Rear Split Folding Seat Back Replacement.




Note: The wheel speed sensor is serviceable only as an assembly. Do NOT attempt to service the sensor harness pigtail.

3. Disconnect the electrical connector (1) from the wheel speed sensor.
4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
5. Pull the sensor harness and grommet out through the body.



6. Remove the bolt (2) which retains the wheel speed sensor harness (1) to the vehicle.



7. Remove the bolt (1) and nut (2) which retains the wheel speed sensor harness to the upper arm and suspension member.



8. Remove the wheel speed sensor retaining bolt (1) and remove the wheel speed sensor (2) from suspension knuckle.

Caution: Refer to Fastener Caution in the Preface section.




1. Install the wheel speed sensor (2) to the steering knuckle.

Tighten
Tighten the rear wheel speed sensor bolt (1) to 8 N·m (71 lb in).




2. Install the bolt (1) and nut (2) which retains the wheel speed sensor harness to the upper arm and suspension member.

Tighten
Tighten the bolt and nut bolt to 5 N·m (44 lb in).




3. Install the bolt (2) which retains the wheel speed sensor harness (1) to the vehicle.

Tighten
Tighten the bolt and nut bolt to 5 N·m (44 lb in).




4. Reposition the wheel speed pigtail harness through the body. Install the grommet.
5. Connect the wheel speed sensor electrical connector (1).
6. Lower the vehicle.
7. Install the rear seat bottom and seat back. Refer to Rear Split Folding Seat Back Replacement.



8. Install the fuel tank filler pipe protector (1). Secure with 3 bolts (2).
9. Perform the Diagnostic System Check - Vehicle.