Electronic Navigation Antenna Replacement Module Assembly Radio Antenna

Important: It is not necessary to lower the steering column to remove the radio antenna module.

1. Remove the navigational radio. Refer to Radio Replacement .



2. Disconnect the electrical connector from the navigational radio (1).
3. Partially remove the instrument panel (I/P) assembly from the I/P structure, to gain access to the antenna module retaining screw. Refer to Instrument Panel Assembly Replacement.
4. Remove the screw retaining the radio antenna module to the cross-car beam (2).
5. Remove the antenna module from the vehicle.

1. Install the antenna module to the vehicle.
2. Install the screw retaining the antenna module to the cross-car beam (2).

Notice: Refer to Fastener Notice in the Preface section.

3. Tighten the screw.

Tighten
Tighten the screw to 2.5 N·m (22 lb in).

4. Install the I/P assembly. Refer to Instrument Panel Assembly Replacement.
5. Connect the electrical connector to the navigational radio (1).
6. Install the navigational radio. Refer to Radio Replacement .