Removal Procedure
Important: If the actuator cover is damaged, the cover can be removed and a new one installed without removing the window panels. Using a flat blade tool, disengage the lower portion of the clip and pull the cover off the window
panel frame. If removing and installing the cover, follow the procedures below.
- Open the sunshade to the full rearward position.
- Remove the 2nd or 3rd sunroof window. Refer to
Sunroof Window Replacement - Middle
.
- Remove the rear sunroof window. Refer to
Sunroof Window Replacement - Rear
.
- Remove the sunroof window side actuator covers (1) from the left and right sides.
Installation Procedure
- Install the rear sunroof window. Refer to
Sunroof Window Replacement - Rear
.
- Install the 2nd or 3rd sunroof window. Refer to
Sunroof Window Replacement - Middle
.
- Install the sunroof actuator cover (1) to the left and right sides, by aligning the cover with the holes in the window frame and press in place.
- Close the sunshade.
- Cycle the sunroof window to ensure proper operation and fit.