Preliminary Procedures

1. Remove the plenum to hood seal plastic retainer. Refer to Seal Replacement - Plenum to Hood.
2. Remove the appropriate headlamp. Refer to Headlamp Replacement.
3. Remove the rocker panel molding. Refer to Rocker Panel Molding Replacement.
4. Remove the front side turn signal lamp assembly. Refer to front side turn signal lamp Replacement Front Side Turn Signal Lamp Replacement.
5. Remove front fender insulator. Refer to Front Fender Insulator Replacement.

1

Front Fender Bolt (Qty: 8)

Caution: Refer to Fastener Caution in the Preface section.

Tip
Use a grease pencil to mark the alignment of the fender before removing the bolts.

Tighten
9 N·m (80 lb in)

2

Front Fender

Procedure

1. Disconnect any electrical connectors.
2. Align the fender after installing as needed.