Caution: Refer to Battery Disconnect Caution in the Preface section.
⢠| Disconnect the 2 wiring harness plugs (1). |
⢠| Remove the 3 bolts (2). |
⢠| Remove the horn switch. |
⢠| Remove the signal switch board (3). |
Notice: Refer to Fastener Notice in the Preface section.
⢠| Insert the signal switch board. |
⢠| Insert the signal switch control. |
Tighten
Tighten the 3 bolts to 2.5 NĀ·m (22 lb in).
⢠| Connect the 2 wiring harness plug. |
⢠| Connect and lock the wiring harness plug. |
⢠| Clamp the airbag unit in place. |
After ignition ON, the airbag system readiness check light comes on for 4 seconds and then goes out.