For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit/System Description
The instrument panel cluster (IPC) illuminates the Antilock Brake System (ABS) indicator by supplying ground to the lamp. The electronic brake control module (EBCM) sends a serial data messages to the IPC, in order to command the indicator ON or OFF.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Electrical Information Reference
Scan Tool Reference
Circuit Verification
Ignition ON, observe the ABS indicator to turn ON then OFF during the IPC bulb test.
Circuit/System Testing
Important: Diagnose all vehicle DTCs before using this diagnostic.
- Ignition On, perform the display test with a scan tool, verify the ABS indicator turns On then OFF.
- Replace the EBCM.
| ⇒ | If the ABS warning lamp does not turn OFF, replace the IPC. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM or IPC replacement, setup, and programming
