- If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
- Remove the tail lamp assembly. Refer to Tail Lamp Replacement .
- Disconnect the rear center roller bracket (4) from the door by removing the pin (1), and slide the door forward.
- Remove the cover (4) at the rear roller assembly (3) behind the tail lamp held on with one TORX screw.
- Remove the sliding door center track cover. Refer to Rear Side Door Center Track Cover Replacement .
- Remove the cable from the rear roller (1) to supply enough cable to remove the center roller bracket (3).
- Reinstall the cable (1) to rear roller and guide (3).
- With tech standing at the center of the rear wheel, grab both cables (1, 2) and pull cables toward each other.
- Hold front cable extended and stationary and pull rear cable outward and hold. Release only the rear cable, while maintaining tension and in the same position as noted for the front cable.
- Pull both cables again. The cables should now be able to pull past each other.
- If barrels do not overlap one inch after relieving tension, repeat steps 8 thru 10 until they overlap.
- Reinstall the cables (3) to the center roller bracket (1) and position the roller bracket into the track, while maintaining the tension on the rear cable.
- Move the center roller bracket toward the front of the vehicle until the roller bracket stops in the track, while keeping tension on the rear cable (2) with the other hand.
- While keeping outward tension on the rear cable and holding down the center roller bracket (1) move the roller bracket rearward, and listen for an audible click to come from the clutch housing.
- Move the roller bracket forward above wheelhouse.
- Hold the roller bracket downward, pull the rear cable outward from inside track and release. The cable should snap quickly back into the track.
- Move the roller bracket forward to the position where the sliding door pin was removed.
- Install the rear roller cover and screw.
- Install the sliding door center track cover. Refer to Rear Side Door Center Track Cover Replacement .
- Install the tail lamp assembly. Refer to Tail Lamp Replacement .
- Install the door center roller bracket (2) to the body roller bracket (4) by installing the pin (1).
- Close and latch the door manually.
- If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
- Operate the door and verify the adjustment.
Important: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.
Disconnect cables from the center roller bracket and remove the center roller bracket from the track.
Note the barrels on the end of the cables will not pull past each other, 25.4 mm (1 in) apart.
Check for limp cables.
Slowly release cables. The barrels at the end of the cables should be overlapping 25.4 mm (1 in).
Important: Tension must be kept on rear cable.
Continue to move roller bracket rearward, in one motion, release the rear cable and finish pushing roller bracket into the track bumper.
Cable is now properly tensioned.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the screw to 9 N·m (80 lb in).
Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Rear Side Door Actuator Control Module Programming and Setup .
