Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List DEFINITION: One or more stop lamps are inoperative or operate dim. | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Depress the brake pedal. Do all of the stop lamps illuminate? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Is only one lamp inoperative? | Go to Step 4 | Go to Step 7 |
4 |
Does the test lamp illuminate? | Go to Step 6 | Go to Step 5 |
5 | Test for a poor connection, open, or a short to ground in the stop lamp supply voltage circuit. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 10 | Go to Step 9 |
6 | Test for a poor connection or an open in the ground circuit of the inoperative stop lamp. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 10 | Go to Step 8 |
7 | Test for a poor connection or an open in the brake pedal position sensor signal circuit of the brake pedal position sensor. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 10 | Go to Step 9 |
8 | Replace the inoperative stop lamp. Refer to the following: Did you complete the repair? | Go to Step 10 | -- |
9 | Replace the body control module (BCM). Refer to Control Module References for replacement, setup, and programming. Did you complete the repair? | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |