GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Clean the clutch fluid reservoir cap and area around the cap.
  2. Remove the clutch fluid reservoir cap and remove enough brake fluid to clear a passage to the clutch master cylinder.

  3. Object Number: 1145170  Size: SH
  4. Remove the clutch pedal retainer.
  5. Remove the clutch master cylinder pushrod from the clutch pedal assembly, 1st design.

  6. Object Number: 1145185  Size: SH
  7. Remove the clutch master cylinder pushrod from the clutch pedal assembly, 2nd design.
  8. Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.


    Object Number: 1145224  Size: SH
  9. Place a shop towel under the clutch master cylinder in order to catch any fluid loss.
  10. Using a pick tool on the strut tower side, disconnect the clutch line from clutch master cylinder.
  11. Cap the reservoir and hydraulic lines in order to prevent fluid loss and contamination.

  12. Object Number: 1145258  Size: SH

    Important: Do not damage the pushrod boot when sliding it through the front of the dash.

  13. Remove the clutch master cylinder mounting nuts and slide the clutch fluid reservoir up and out.

Installation Procedure


    Object Number: 1145258  Size: SH

    Important: Do not damage the pushrod boot when sliding it through the front of the dash.

  1. Uncap the fluid reservoir and hydraulic lines.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Slide the clutch fluid reservoir into the mounting slot and install the clutch master cylinder mounting nuts.
  4. Tighten
    Tighten the nuts to 23 N·m (17 lb ft).


    Object Number: 1145170  Size: SH
  5. Install the clutch master cylinder pushrod to the clutch pedal assembly, 1st design.
  6. Install the clutch pedal retainer.

  7. Object Number: 1145185  Size: SH
  8. Install the clutch master cylinder pushrod to the clutch pedal assembly, 2nd design.

  9. Object Number: 1145224  Size: SH
  10. Remove the shop towel and discard into a suitable container.
  11. Connect the clutch line to the clutch master cylinder.

  12. Object Number: 1145261  Size: SH
  13. Connect the clutch master cylinder pushrod to the clutch pedal.
  14. Install the clutch pedal retainer, nuts and bolts.
  15. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding .