Removal Procedure
Notice: The new SIR coil assembly will be centered. Improper alignment of the
SIR coil assembly may damage the unit, causing an inflatable restraint malfunction.
- Place the front wheels in the straight forward position with the steering wheel centered.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
.
- Remove the inflatable restraint steering wheel module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
.
- Remove the steering wheel. Refer to
Steering Wheel Replacement
.
- Remove the steering column covers. Refer to
Steering Column Trim Covers Replacement
.
- Release the SIR coil harness clips from the bracket below the column.
- Disconnect both the SIR coil and horn/cruise connectors.
- Using a small flat-bladed tool, carefully pry the retaining tabs away from the SIR coil assembly and slide the SIR coil assembly off the steering column.
Installation Procedure
Important: A new roll connector is equipped with a yellow tab that is removed after the steering wheel is installed. This tab passes through the steering wheel.
- Route the SIR wiring harness and horn/cruise connector down steering column.
- Snap the SIR coil into position on the column.
- Connect the SIR coil and horn/cruise electrical connectors.
- Attach the wiring harness clips to the bracket below the column.
- Install the steering column covers. Refer to
Steering Column Trim Covers Replacement
.
- Install the steering wheel. Refer to
Steering Wheel Replacement
.
- Install the inflatable restraint steering wheel module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
.