For 1990-2009 cars only
- Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
- If installing the existing inflatable restraint steering wheel module coil it must be centered first. Refer to Inflatable Restraint Coil Centering - Off Vehicle .
- Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
- Slide the inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
- Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
- Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (4).
- Connect the connector of the inflatable restraint steering wheel module coil to the wire harness assembly.
- Install the upper and lower trim cover. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
- Install the steering column into the vehicle. Refer to Steering Column Replacement .
- Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Important: A new inflatable restraint steering wheel module coil is pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.
Caution: Refer to SIR Inflator Module Coil Caution in the Preface section.
