GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Corvette 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 4L60-E/4L65-E 🢒 Floor Shift Control Boot Replacement

Removal Procedure

    Object Number: 71447 Size: SH
  1. Remove the console. Refer to Console Replacement in Instrument Panel, Gauges and Console.
  2. Remove the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
  3. Remove the floor shift control knob.
    4. 3.1. Using a flat-bladed screwdriver, carefully pry the staple clip from the knob.
    3.2. Remove the knob from the floor shift control.
  4. Remove the floor shift control from the vehicle; to allow for boot replacement without possible damage to the boot retaining tabs. Refer to Transmission Control Replacement .

    5. Object Number: 190951 Size: SH
  5. Remove the floor shift control boot from the floor shift control.
    6. 5.1. Carefully squeeze the front and side tabs or the rear and side tabs at the same time in order to release them.
    5.2. Carefully squeeze the remaining tab in order to release it.
    5.3. Release the snap lock retainer on the LH side of the boot.
    5.4. Move the boot to the left and release the shift indicator guide pin from the shift control lever.
    5.5. Disconnect the indicator lamp socket from the boot.
    5.6. Remove the boot from the shift control.

Installation Procedure

    Object Number: 190951 Size: SH
  1. Install the floor shift control boot to the floor shift control.
    2. 1.1. Position the boot onto the shifter.
    1.2. Align the shift indicator guide pin to the slot in the boot, then move the boot to the right to insert the guide pin into the slot.
    1.3. Connect the shift indicator lamp socket to the boot.
    1.4. Evenly insert the tabs until the boot locks into position.

    Object Number: 71447 Size: SH
  2. Install the floor shift control to the vehicle. Refer to Transmission Control Replacement .
  3. Install the shift control knob.
    4. 3.1. Install the knob onto the shift control.
    3.2. Install the staple clip.
  4. Install the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
  5. Install the console. Refer to Console Replacement in Instrument Panel, Gauges and Console.