Console Replacement Luxury Console
Removal Procedure
- Remove both front seats. Refer to
Front Seat Replacement - Bucket
in Seats.
- Remove the console bezel. Refer to
Floor Console Bezel Replacement
.
- Remove the two bolts (1)
attaching the floor console to the front extension.
- Remove the bolt (2) attaching the floor console to the subwoofer
box, if equipped.
- Lift up the console assembly from the floor studs and move rearwards
to gain access to the wire harness connector.
- Disconnect the wire connector.
- Remove the console assembly (3) from the vehicle.
Installation Procedure
- Place the console assembly in the vehicle
in other to connect the wire connector.
- Connect the wire connector.
- Install the console over the studs.
Notice: Refer to Fastener Notice in the Preface section.
- Install the two front console bolts (1) to the front extension.
Tighten
Tighten the two bolts to 1.6 N·m (14 lb in).
- Install the bolt (2) to the subwoofer box, if equipped.
Tighten
Tighten the bolt to 1.6 N·m (14 lb in).
- Install the console bezel. Refer to
Floor Console Bezel Replacement
.
- Install both front seats. Refer to
Front Seat Replacement - Bucket
in Seats.
Console Replacement Base Console
Removal Procedure
- Open the center console door.
- Remove the 4 bolts attaching
the center console to the console bracket.
- Remove by lifting the center console from the bracket.
Installation Procedure
- The new console is attached to a bracket.
Separate the center console from the bracket by removing the retaining
bolts.
- Position the new center console on the bracket in the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the 4 retaining bolts to the bracket.
Tighten
Tighten the bolts to 3.5 N·m (31 lb in).
- Close the center console door.
Console Replacement Pro
Removal Procedure
- Remove the cupholder assembly. Refer to
Cupholder Replacement
.
- Remove the console lid and bin assembly. Refer to
Front Floor Console Compartment Replacement
.
- Remove
the 6 console retaining bolts (1).
- Lift up the console slightly in order to disconnect the wire connectors.
- Remove the console from the bracket.
Installation Procedure
- Place the console on the bracket.
- Connect all the wire connectors.
Notice: Refer to Fastener Notice in the Preface section.
- Install the 6 console retaining bolts (1) to the I/P extension.
Tighten
Tighten the 6 retaining bolts to 1.6 N·m (14 lb in).
- Install the console lid and bin assembly. Refer to
Front Floor Console Compartment Replacement
.
- Install the cupholder assembly. Refer to
Cupholder Replacement
.