IMPORTANT: When performing the following checks, maintain some moisture on the front windshield so that the wiper motor does not overheat.

1

1. Turn the ignition switch to the ON position.
2. Leave the Wiper Switch in the OFF position.
3. Depress the washer switch for 2 to 4 seconds and release.

Refer to Washers Inoperative .

2

1. Move the wiper switch to the INT position.
2. Rotate the INT ADJ switch from the high to low delay position.

Refer to Wipers Delay Mode Inoperative .

3

1. Leave the wiper switch in the INT position.
2. Depress the washer switch for 2 to 4 seconds and release.

4

Move the wiper switch to the LO position.

Wipers run continuously at low speed.

Refer to Wipers All Modes Inoperative

5

Move the wiper switch to the HI position.

Wipers run continuously at high speed.

6

Move the wiper switch to the OFF position.

Wipers return to the park position at low speed.

Refer to Wipers Always On .

7

Move the wiper switch to the MIST position and then release.

Wipers make one complete sweep, then return to the park position.

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.

1

Place the rear wiper/washer switch in the DELAY position.

Wiper makes one complete sweep and pauses before making the next sweep

Refer to Wipers Delay Mode Inoperative

2

Place the rear wiper/washer switch in the ON position.

The rear wiper operates in full continuous sweeps.

Refer to Rear Wiper Inoperative

3

Depress the rear washer switch for 2 to 4 seconds and release.

The rear washer sprays as long as the rear washer switch is depressed.

Refer to Rear Washer Inoperative

4

Place the rear wiper/washer switch in the OFF position.

The rear wiper returns to the PARK position.

Refer to Rear Wiper Always On

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.