Instrument Cluster Replacement Chevrolet

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Disable the SIR system. Refer to Disabling the SIR System in SIR.
3. Remove the instrument panel trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
4. Remove the screws (6) from the top of the cluster (5).
5. Pull the cluster (5) rearward.
6. Remove the cluster (5).

1. Install the cluster (5) to the instrument panel (3).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screws (6) at the top of the cluster (5).

Tighten
Tighten the screws to 2 N·m (18 lb in).

3. Install the instrument panel trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
4. Connect the negative battery cable.
5. Enable the SIR system. Refer to Enabling the SIR System in SIR.
6. Disengage the theft deterrent tamper mode. Refer to PASSLOCK Changing - Components Description in Theft Deterrent.

Instrument Cluster Replacement Pontiac

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Disable the SIR system. Refer to Disabling the SIR System in SIR.
3. Remove the instrument panel trim pad. Refer to Instrument Panel Trim Pad Replacement
4. Remove the screws (1,3) from the top of the cluster (2).
5. Pull the cluster (2) rearward.
6. Remove the cluster (2).

1. Install the cluster (2) to the instrument panel.
2. Install the screws (1, 3) at the top of the cluster (2).
3. Install the instrument panel trim pad. Refer to Instrument Panel Trim Pad Replacement .
4. Connect the negative battery cable.
5. Enable the SIR system. Refer to Enabling the SIR System in SIR.
6. Disengage the theft deterrent tamper mode. Refer to PASSLOCK Changing - Components Description in Theft Deterrent.