GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2002 🢒 DeVille 🢒 Steering 🢒 Steering Wheel and Column 🢒 Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle

    Object Number: 324871 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the ignition and key alarm switch assembly (2) and secure by using 2 tapping screws (3).

    2. Tighten
    Tighten the screws to 1.5 N·m (13 lb in).

  2. Install the ignition and key alarm connector (1) onto the lock module assembly (4).
  3. Install the green connector into the bottom of the ignition and key alarm switch assembly (2).
  4. Put the lead in the clip located on the side of the ignition and key alarm switch assembly (2).

    5. Object Number: 324869 Size: SH
  5. Install the coded key controller (2) onto the lock module assembly (1).

    6. Object Number: 420192 Size: SH
  6. Connect the coded key controller.
  7. Install the upper and lower trim cover. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
  8. Install the steering column lock cylinder set. Refer to Ignition Lock Cylinder Replacement - On Vehicle .
  9. Install the steering column into the vehicle. Refer to Steering Column Replacement .
  10. Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
  11. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.